Repeatedly press FUNC then 9 to select the offset frequency you want ( 12.5 kHz, 25.0 kHz, or 50 kHz). 12.5 kHz (the default offset frequency) appears.ĥ. Press TRUNK then repeatedly press MODE to select MO (Motorola).Ĥ. Note: You must store frequencies using the subaudible trunking method in banks mode by mode.ģ. Store the base frequency into channel 00 of the bank you selected, then store the trunking frequencies into subsequent channels in the same bank (see “Storing a Frequency While Searching for a Specified Channel” on ). Select the bank, then press PGM to enter the program mode.Ģ. Programming Motorola Trunking Frequencies in theġ. You can get information about these frequencies for the trunking system you want to scan using other Internet sources, or locally published guide. Base and offset frequencies vary for each type of trunking system.When you do this, the scanner might detect wrong IDs, but you can easily receive trunking frequencies without programming the base and offset frequencies. Decoding the subaudible data transmitted with the signals.You must program the system’s base frequency and offset frequency to do this. Checking the trunking system’s control channel.You can program the scanner to receive transmissions in the UHFLo band (380–512 MHz) of the Motorola trunking system. Receiving Motorola Trunking Systems in the Turn off the scanner to remove the lockouts. See “Locking Out Channels or Frequencies” on. If you are scanning VHF and UHF trunking frequencies under the 512 MHz range using subaudible data and are not using a base frequency and offset, lock out all data channels. For some Motorola (under 512 MHz range) and LTR systems, the scanner uses the subaudible data sent with each transmission to identify talk groups. This addendum describes the changed operations of your scanner.įor EDACS and Motorola (above 806 MHz range) trunking systems, the scanner monitors the control channel between each transmission to identify talk groups.
0 kommentar(er)
